Warm tips about Ink cartridge installation and maintenance

Posted by Hao Yang on

Ink cartridge installation and maintenance

Storage:Please store in a cool dry place.

Don’t open the package until you are ready to use the cartridge.Please avoid contact with chip or electrics when opening the bag.

For Best results: For Epson and Brother cartridge please remove yellow tab located on the top of the cartridge or remove the black/yellow cap and install as normal.please note for Epson please remove black spacer.

For best results: For Canon please remove orange or yellow tab located on top of the cartridge before removing the orange cap on the bottom then install as normal.

For best results: For HP 10/11/82/84/85/88 Cartridges please remove yellow tab located on top of the cartridge and install as normal.

For best result: For HP,Lexmark,Samsung,Dell Remanufatured cartridges please remove clip and remove the transparent blue tape on the electric then install as normal.

Perform a nozzle clean once the cartridge has been installed.Repeat this process if necessary.

The cartridge must be used within six months after installation.Repeat this process if necessary.

The cartridge must be used within six months after installation.Run your printer at least once a week to maintain your machines printheads.

It is important if the cartridges do not register to remove and reinstall the cartridge as normal then continue to print,in the event you find that the print is not good please leave the cartridges in the machine for a further 5 mins then perform a nozzle clean(please check owners manual for instructions).With Epson cartridge you may get a message stating this is not an Original Supply please press continue to print as normal.


Share this post



← Older Post Newer Post →


Leave a comment

Please note, comments must be approved before they are published.

Sale

Unavailable

Sold Out